+1-844-4ATTACH

Generic Shaft Mount Fork – Form-GSF

Generic Shaft Mount Fork Diagram

PROPRIETARY AND CONFIDENTIAL

THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF ALL-PRO.
ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF ALL-PRO IS PROHIBITED.
Generic Shaft Mount Fork
  • OS:
    		 Offset, eye center is off the back of the fork.
    		The desired measurement is from the eye center to the back of the fork.
    IS:
    		Inset, eye center is in front of the fork back.
    		The desired measurement is from the eye center to the back of the fork.
    RS:
    		Rearset, the eye is set on the fork back.
    		The desired measurement is from the eye center to the back of the fork.
  • IL:
    		 Inline, the eye center is even with the fork back. No measurement needed.
    B:
    		The height from the eye center to the heel of the fork.
      The desired measurement is from the eye center to the heel where the fork would contact the ground.
    • X
    M
    Eye Set (choose one)

    Contact Info

    UNLESS OTHERWISE
    SPECIFIED: DIMENSIONS ARE IN INCHES
    TOLERANCES:
    FRACTIONAL ± .5
    ANGULAR: MACH ± .5 Deg
    TWO PLACE DECIMAL ± .25
    THREE PLACE DECIMAL ± .125

    All dimensions may have a ± factor to accomodate metric conversion. Forks are quoted according to these specs. Changes may affect pricing. Specs must be verified as accurate. Forks produced to verified specs are non-returnable, and cannot be cancelled.

    Download Form as PDF
    Internet Marketing Solution & Design by Cazbah